The electric window system is composed of windows, window lifters, motors, relays, switches and other devices. Electric windows are a very convenient design. Let's explain common faults and maintenance tips for electric windows today. The electric window system is composed of windows, window lifters, motors, relays, switches and other devices. The general electric window system is equipped with two sets of control switches. A set is on the dashboard or the driver's side door armrest, the main switch, which controls the lift of each window by the driver. The other set is mounted on each passenger door, which is divided into switches and can be operated by passengers. In general, the main switch is also equipped with a disconnect switch. If it is disconnected, the switch does not work. The electric window is a very convenient design when it is charged at a parking lot or when it is bought at a fast food shop. Its mechanical device is not complicated and fuel supply is the mainstay of maintenance. However, since the mechanism is located inside the door, the inner cover needs to be removed. The concealed screws securing the inner cover can be found inside the recess of the door handle. The use of gears, wire rope device to the arm fulcrum and the slider part of the refueling center. It is very important to restore the original shape of the waterproof plastic under the inner cover. The stain on the window glass not only affects the appearance but also affects the field of view. Excessive dirt affects the operation of the electric switch window. Prevents rain from flowing into the car. A rubber band is attached to the top of the window frame. This is also where the glass is often in contact. After the glass is dirty, the friction with the rubber band increases, and the switch is also affected, so the glass must be kept clean constantly. The power consumption of the electric switch window is very large. The moment of activation in the slow state may even cause the sound of the engine to change. Therefore, in a car with a weak battery, be careful not to open or close the window at the same time. 1. The reason why the electric switch window does not move smoothly is that the oil in the internal door lifter is exhausted. The inner cover should be removed and the oil must be removed. 2. If the glass does not operate at all, there may be a switch failure. If it is a switch failure, it can only be replaced. 3. If the electronic device does not operate, it is common sense to check the fuse. Carefully check that the fuse is for a power window. 4. When the operation of the switch deteriorates and the window does not open smoothly, there is a high possibility that the switch will malfunction. 5. Before refueling the internal mechanism, first remove the inner cover. Remove the hidden screws and remove the snap switch. 6. Remove the inner cover and peel off the waterproof plastic sheet below to expose the lifting mechanism of the window. 7. Spray grease on the arm fulcrum and gear. While moving up and down, spraying can also coat very small parts. 8. The slider part at both ends of the support glass also needs to be checked. When the sliding condition of glass and heat conduction is poor, a brightener can be applied. 9. In order for the glass to slide smoothly, it is important to minimize resistance. Deterioration of glass can also become resistance, and windows should always be kept clean. EVA Colorful Building Blocks is consist of four different but classical colors. Made from Eco-friendly, closed cell, non-smell and non-toxic EVA foam material, passes ASTM and EN71 certificates, the safety of this product is the last thing needs to be worried. Eva Colorful Building Blocks,Colorful Building Blocks,Colorful Eva Foam Building Block,Eva Colorful Foam Building Block,Colorful Foam Building Block,Colorful Educational Building Block Huizhou City Melors Plastic Products Co., Limited , https://www.melorsmarine.com
The foam building blocks are easy to store and carry cause it is packed with a PVC bag with zipper. Also after a long time of playing, the blocks can be cleaned easily with water thanks to its closed cell foam.
Power window maintenance tips