1. Place the door frame and door cover of the quick stacking door on the ground, carry out pre-measurement, drawing, and use the electric drill to make eye-catching, and prepare for the fixed work.
2. Install dustproof and windproof brush on both sides of the door frame, which can be fixed by rivets, or you can use the plastic steel buckle to install the brush, which is simple and convenient.
3. Connect the wires to the motor and the stopper and fix the seat belt at the bearing.
4. Erect the door frame and the door cover, and use the infrared level to measure whether the ground height of the two-framed Julian forest is consistent. If it is consistent, continue the fixed work.
5. Install the motor and the limiter and shun all the circuit lines. Install the infrared system at the same height of the fast door frames on both sides.
6, using a toothless saw to cut the coil, into the ground sense line.
7. Turn on the line and use the motor drive to raise the curtain to the appropriate height and fix it to adjust the upper and lower limits.
8. Install the upper door cover and motor cover.
Vacuum Forming Car Parts
Vacuum forming is a manufacturing process used to create car parts by heating a plastic sheet and then stretching it over a mold using vacuum pressure.
You may probably find the automotive industry is the most made by vacuum forming,both for comsumer and commercial vehicles,trucks, and buses.Usually the vacuum forming car parts contain:Front bumper, rear bumper, ceiling, roof luggage compartment, wheel arches, doors, tailgate padding, dashboard, fenders, car logo, and interior and exterior plastic decorations.
In addition, the plastic trays which are used for the transportation of the engine block and cylinder also was made by vacuum forming.
Vacuum Forming Car Parts,Vacuum Forming Auto Parts,Thermoforming Car Parts,Thermoforming Auto Carts
Dongguan Yiyongli Industrial Co.,Ltd. , https://www.absthermoforming.com
